产品中心
速冷速热高光模温机

GWTCH 急冷急热模温机

WMCH rapid cool and heat mold temperature controller

 

            : GWTCH

Model: GWTCH
             : 注塑行业 

Type: Plastic injection industry

>>应用范围     显示器、家电、空调、光学、车灯、通讯等产品之精密快速射出成型
Application range:Use high-pressure high -volume pump ,heating ,cooling rapidly ,with rapid injection molding.

 


   配合射出机信号,根据系统注塑成型工艺要求输出热水或冰水(冷却水)

With signal injection machine, injection molding process in accordance with system requirements of the output hot water or cold water(cooling water) to ensure the injection mold, when in touch all the good flow of plastic to eliminate air bubbles

   
   模温机热水最高使用温度140/180

2.The highest mold temperature the machines used hot water temperature max. 140/180
   
   采用大流量泵浦,升温、降温迅速,配合快速成型射出

Use high-pressure high-volume pump, heating, cooling rapidly, with rapid injection molding
   
   具备模具回水功能、有效缩小热能量损耗、省电、缩短成型周期

Have the function of water recovery, hot water energy recovering efficiently, water saving, shortening the molding cycle
   
   注塑产品无结合线、无流痕、无气泡、不用喷涂二次加工、降低制造成本

.No bonded line on high-lighted surface of injecttion product, no flow marks, no bubbles, no secondary processing of spraying, lower manufacturing costs
   
   小投资,单机搞定,不用锅炉等大投资.
.Small investment to get stand-alone, not big investment as the boiler

 


总电源过电流无熔丝断路器Circuit breaker        

异常警报蜂鸣器Alarm sounding
 ●
马达反转保护及指示灯Oil lack protective lamp            

出水压力表 Water output pressure gauge
冷却水缺水保护及指示灯Cooling water less protective lamp         

过热保护温度开关Overheat protective lamp
循环泵浦过载保护及指示灯Circuiting pump overload protective lamp        

回水温度显示表Water return temp. display
●By-Pass
泄压回路   By-pass pressure release circuit             

电源欠相保护Power protection




Copyright © 广州万举机械威尼斯彩票历史记录 冷水机,模温机,油加热器厂
顶部